Since those are used for word processing and not routing or engraving you will generally not have any single line fonts available. The comments below were added after this Forum discussion was archived as a Knowledge Base article ( add your comment).ĮnRoute only shows you the fonts that are in your Windows font library. This can approximate a single line, by using the standard engrave toolpath, which will go around twice. If you only have 2-D Enroute, try inline offsetting with rounded corners by an amount just less than half the distance between the font lines. With a plain font like Simplex, the results should be just fine. The bit will even rise up into the corners, to make them sharp. Use a 90 degree conic bit, and this will go down the center between the two "hollow" font lines, and only deep enough to touch both lines. If you have 3-D Enroute, look for the check box for "3-D engrave toolpaths" in the "Engrave Parameters" box. Sometimes they get messed up going from AutoCAD to importing the stuff into a cam program, so just have to make sure everything is converted to a vector format so it is more universal between applications/programs. I like getting scripted fonts there for vcarving and thicker fonts for relief/2d profiling. Some cam programs can understand it and make toolpaths for them with no problem, but some won't. Many won't work very well because the vector lines will end up overlapping. I get most of my fonts from, I believe they are almost all free. With single line fonts, I will be able to rout the letter to whatever depth I want and it will only get deeper as to cutter width, not letter width. This makes the letters too wide or it will rout them twice inside, leaving a ridge in the rout. So when I run them, I can only run the inside width of the letter, not depth that I want. I can do the same thing in Enroute with the fonts I have but it brings them in hollow, not single line fonts. Then I can use that exploded text to route. I don't know about KCDw, but I know that I can explode any font in AutoCAD using explode text command located in text menu in express tools. I use Enroute and KCDw on my router and need some fonts for certain projects. I don't want to spend a lot of money for a big program when all I want is a few types of letters for my projects that I rout. I am still looking for single line fonts and am having trouble finding one that will work for me.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |